Pet Blowing Machine Common Fault

Four common faults in pet blowing machine 1. Light box sink high temperature alarm Method: Open the water path connecting the rubber tube, and purge and clean the water path with low pressure gas and alcohol. 2. Gripper troubleshooting: Adjust the slider height or jaw position. 3. The action is stagnant. Solution: Restart the machine. 4. The method of not manually originating: View moving a jaw, moving the two jaws and variable pitch positioning plate, whether to put the card in the proper position, if not, let them manually put the card in the appropriate position, then the origin. 5. Treatment measures are not in place: check for cards. Adjusting the gas flow valve 6. Exhaust sound processing method: Check if the high pressure exhaust muffler is damaged or detached 7. Non-uniform treatment of embryos: adjust the position of the embryo barrel. Daily maintenance. 1. You can slide the rails and apply butter once a day. 2. Fuel the nozzle once a week. 3. Heat the track, blow the track, and see the liquid lubricant drop. 4. Wipe the mold once a week with a clean cloth and alcohol. The bottle is usually observed for pitting pits and the corresponding position is found after the Pet Bottle Preform mold is removed. 5. Usually pay attention to the blown body, the internal sanitation is clean, to see if it can remove the stolen goods in time. 6. Pay more attention to the moving part of the screw, the position of the electronic sensor, and find that the looseness or displacement is tightened or corrected in time. 7. Turn off the machine for a long time to close the intake valve. Such as rear maintenance equipment, food, etc. Turn off the production line for a long time and turn off the main power of the machine.